真空吸塵器電子元件非正常運行測試(doc 4頁)

真空吸塵器電子元件非正常運行測試內容提要：
1.0 Purpose / 目的
To evaluate if the sample operated with the electronic components short-circuited or/and open can conform to the relevant safety requirements in UL1017.
評估樣機電子組件在短路和/或斷路非正常運行狀況下是否符合UL1017安全標準.
2.0 Definition/概念:
None 無
3.0 Reference Documents/參考文獻:
U.L.1017 CAN/CSA-C22.2 NO.243-01, dated 12-07-2001,Cl 5.10.2
4.0 Equipment/設備:
4.1 Frequency converter. (變頻電源).
4.2 Stop watch(秒表)
4.3 UL finger (UL手指)
4.4 3 ampere non-time delay type fuse( 3A快速保險,插頭型)
4.5 Withstanding voltage tester. (耐壓測試儀)
4.6 White tissue paper(白紙).
4.7 Cheesecloth. (紗布)
4.8 Softwood board(軟木板)
4.9 Digital multimeter(萬用表)
5.0 General Instructions/說明:
5.1 Tests may be conducted at any ambient temperature within a range of 10-40℃ (50-100℉).
測試可在10~40℃(50~100℉)之內的環境溫度下進行.
5.2 Unless otherwise noted, all tests are to be conducted with appliance connected to a 120VAC, 60Hz power source.
除非另外標注,否則所有樣機都將連接在120V/60Hz電源下進行測試.
5.3 All equipment used must be calibrated on an annual basis. Calibration stickers with last calibration and calibration due date must be affixed to each instrument.
使用的所有設備都必須以一年為周期進行調校.載有最後調校日期和調校周期的調校粘紙必須粘固在每一個儀表上.
..............................